Wasp WPL 406 Manual de usuario descargar pdf (Pagina 78)

73

WPL 406 User Manual

Poor Print Quality

* Ribbon and media is loaded

incorrectly

* Dust or adhesive accumulation on

the print head.

* Print density is not set properly.

* Printhead element is damaged.

* Ribbon and media are

incompatible.

* The printhead pressure is not set

properly.

* Reload the supply.

* Clean the printhead.

* Clean the platen roller.

* Adjust the print density and print

speed.

* Run printer self-test and check th

e

print head test pattern if there

is

dot missing in the pattern.

* Change proper ribbon or proper

label media.

* Adjust the printhead pressure

adjustment knob.

- If the left side printout is too ligh

t,

please adjust the left side

pressure adjustment knob to the

higher index (higher pressure). If

the pressure adjustment knob

has been adjust to index “5” and

the poor print quality is still at

the

left side of the printout, press

ure

adjustment knob to index “1” an

d

use the Z-axis adjustment knob

to fine tune the pressure.

- If the right side printout is too

light, please adjust the right side

pressure adjustment knob to the

higher index (higher pressure) If

the pressure adjustment knob

has been adjust to index “5” and

the poor print quality is still at the

right side of the printout,

pressure adjustment knob to

index “1” and use the Z-axis

adjustment knob to fine tune the

pressure.

* The release lever does not latch

the printhead properly.

LCD panel is dark but the

LEDs

are

light

* The printer initialization is

unsuccessful.

* Turn OFF and ON the printer

again.

* Initialize the printer.

LCD panel is dark and LEDs

are

lit on, but the label is

feeding

forward

* The LCD panel harness connect

or

is loose.

* The LCD panel harness connect

or

is plugged upside down.

Cutter is not working

* The connector is loose.

* Plug in the connect cable

correctly.

Label feeding is not stable

(skew)

when

printing

* The media guide does not touch

the edge of the media.

* If the label is moving to the right

side, please move the label guid

e

to left.

* If the label is moving to the lef

t

side, please move the label guid

e

to right.

Skip labels when printing

* Label size is not specified

properly.

* Sensor sensitivity is not set

properly.

* The media sensor is covered wi

th

dust.

* Check if label size is setup

correctly.

* Calibrate the sensor by Auto Gap

or Manual Gap options.

* Clear the GAP/Black mark sens

or

by blower.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83

Comentarios a estos manuales

Sin comentarios