Wasp WPL305 Guía de usuario

WPL305 Thermal Label Printer User’s Guide For Wasp Technologies DT/TT Printer  Copyright Wasp Bar Code Technologies 2004. All rig

4. Power on Utilities There are three power-on utilities to set up and test printer hardware. 1. Printer initialization 2. Ribbon sensor calibratio

4.2 Ribbon Sensor Calibration Note: Please make sure the ribbon is properly installed before doing this calibration. Please follow the steps below to

Print head check pattern Firmware version Firmware checksum Printed mileage (meter) Serial port configuration Country code Print speed (inch/sec) Pr

The printer will enter dump mode after printing the printer configuration. In dump mode, all characters will be printed in 2 columns as in the figure

5. Maintenance 5.1 Cleaning Use one or more of the following supplies that meets your needs:  Cleaning pens  Cleaning swabs  Lint-free cloth

The printer is paused. 3. 4.  Press the feed button to resume printing. The printer is out of label or ribbon or the printer settings are not corre

7. Specifications 7.1 Printer Specifications Item W305 Mechanism Resolution 203 dpi. Max. Print Width 108 mm. Max. Print Length 1000 mm ( 39” ). Ri

2D: PDF-417, Maxicode, and DataMatrix. Command Set WPL Environment Operation Temperature: 5 ~ 40. Relative Humidity: 25% ~ 85% (Non Condensing)

168. Product Support If you experience any problems with your Wasp printer that you are unable to resolve, use our online support site to register th

Contents 1. Introduction...1 2. Getting Started ...

1. Introduction Thank you for purchasing the W305 Thermal Transfer and Direct Thermal Bar Code Printer. Although the printer takes only a small amount

2.3 Printer Parts Ribbon Access Window Top Cover Open Lever Feed Button Printer Top Cover LED IndicatorFigure 1: Top front view 3. Setup 3.1 Settin

3.2 Loading the Ribbon The printer automatically detects if a ribbon is installed after power on and will switch to thermal transfer or direct therma

Figure 3: Ribbon installation 6. Attach the ribbon spindle to the Back Hub by placing the left side of the spindle against the knob with the spring o

Lower Cover Figure 5: Pull the lever to open the cover 3. Place the roll of labels onto the center of the paper roll mount. Printer Top Cove

cover. 2. Do not allow the top cover to slam closed. 3. Failure to securely close and lock the cover will result in poor print quality. 3.7 Top C

when closing the top cover! Figure 8: Top cover is fully open and ready to close Figure 9: Use both hands to close the top cover 5. Do not force