Wasp WPS100 Especificaciones descargar pdf (Pagina 42)

100

101

4-2

Wasp WPS100 Product Reference Guide

If you are not using a USB cable, you must select a host type (see each host chapter for

specific host information). After you hear the power-up beeps, select a host type. This only

needs to be done once, upon the first power-up when connected to a new host.

To return all features to their default values, all you need to do is scan the Set All Defaults

bar code on page 4-5. Throughout the programming bar code menus, default values are

indicated with asterisks (

*).

Scanning Sequence Examples

In most cases you need only scan one bar code to set a specific parameter value. For

example, if you want to set the beeper tone to high, simply scan the High Frequency

(beeper tone) bar code listed under Beeper Tone on page 4-6. The scanner issues a short

high beep and the LED turns green, signifying a successful parameter entry.

Other parameters, such as specifying Serial Response Time-Out or setting Data

Transmission Formats, require that you scan several bar codes. Refer to Host Serial

Response Time-out on page 6-20 and Scan Data Options on page 8-9 for descriptions of

this procedure.

Errors While Scanning

Unless otherwise specified, if you make an error during a scanning sequence, just re-scan

the correct parameter.

*High Frequency

Feature/Option

* Indicates Default

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 465 466

Comentarios a estos manuales

Sin comentarios

Wasp WPS100 Especificaciones Pagina 42

Comentarios a estos manuales